Technical Substructure Defense & High-Pressure Leak Remediation
Thermal movement in the Saudi climate demands high-performance structural detailing. EG-CORE utilizes Technical TPE Membranes—not basic sealants. These membranes are chemically fused to the concrete shoulders using high-modulus epoxy, providing a waterproof bridge capable of handling extreme seismic drift without adhesive failure.
Meets ASTM D-412 for 400%+ elongation. Optimized for Riyadh parking decks and industrial roof slabs.
Epoxy bond values exceeding 3.5 MPa ensure the system remains monolithic with the structure under load.
In Saudi substructures, every tie-rod hole is a potential hydraulic breach. Our Triple-Shield Protocol kills active leaks through a focused 3-step repair: deep core excavation, high-expansion hydrophilic pressure plugs, and a final crystalline fusion to resist high-head water pressure.
Deep-set hydrophilic plugs swell 300% upon water contact, creating an internal mechanical cork in the wall core.
Crystalline mortars grow insoluble fibers into the concrete matrix, turning the repair into a permanent part of the wall.
Fillets are a technical mandate for every KSA foundation junction—rafts, tanks, and retaining walls. 90° angles cause membrane stress and thinning. We engineer 50mm radius Polymer-Modified Coving to ensure uniform coating thickness and eliminate stress-concentration failure points.
Redirects hydrostatic loads across the joint, preventing the "tearing effect" common in standard junctions.
Constructed from high-compressive, zero-shrink structural mortars for lifetime durability in saline soils.
Membranes are required for Saudi projects where joints exceed 30mm or experience thermal drift that would cause liquid sealants to snap.
A 5cm depth is the KSA engineering standard to remove formwork cones and allow the hydrophilic plug to sit in the neutral wall axis.
Crystalline technology uses the presence of moisture to trigger a chemical growth that permanently blocks the concrete capillaries.
Absolutely. High-pressure tanks in Riyadh and Jeddah require coving to prevent liner failure at the high-stress wall-to-floor junctions.
Groundwater in the Eastern Province is highly corrosive. Our TPE and epoxy systems are 100% resistant to sulfate and chloride ions.
Yes. Our industrial epoxies are moisture-tolerant, allowing for maximum bond strength even in high-humidity coastal construction zones.
